Sniper-AS giveds a quick presentation of the Lancer Tactical LT-51S AKS-74M ETU Proline G2 AEG they have in stock... "PRODUCT INFORMATION "LT-51S AKS-74M ETU PROLINE G2 FULL STEEL (S)AEG"Housing made of stamped steel, Mosfet , electronic trigger ( ETU ), handguard and solid stock made of real wood!

The AK 74 assault rifle has been manufactured and used since 1976 to this day. The AK 74 is equipped with a sheet steel housing and a real wood handguard and sheepskin. Pure realism is offered to you.

The one-piece outer barrel with a height-adjustable front sight and removable flash hider is made of sturdy aluminum. A two-part handguard made of high-quality plastic is attached over the outer barrel. The entire front system sits very firmly on the main case and makes a stable impression.

The lower main body of the Lancer Tactical AK is made of strong sheet steel. Thanks to the thickness of the material, the receiver is particularly robust and ideally suited for tough gaming use. Like the original, the upper cover is also made of sheet steel. The battery is also inserted under this cover. All common Lipo batteries with a Tamyia connection fit.
The typical fire selector or safety lever is mounted on the right of the housing, just like the original. Below is a nylon fiber grip with structuring in the well-known AK-74 look.

Inside the AK 74 is a so-called V3 Gearbox with 8 mm ball bearings. The gears are made of high quality steel. theAirsoft naturally has an adjustable hop-up to straighten the trajectory on the vertical axis. This gives the possibility to use different balls (different manufacturers) and different weights. The energy of the electric airsoft is in the range of approx. 1.3 joules and was measured with 0.20g BBs.

The most important development of the new Generation 2 Proline is undoubtedly the addition of an electronic ETUtrigger and a protective mosfet. This trigger allows for increased response, finer recoil sensitivity, battery voltage protection, collet gear cycles, spring preload for a much faster shot launch, etc... small revolution, always at an affordable price.

This airsoft gun is a so-called SAEG , i.e. a semi-automatic, electric airsoft gun. This means that every shot must be triggered by the shooter pulling the trigger, but is automatically reloaded by the weapon. To operate the electric Airsoft you need a battery (we recommend a so-called Lipo battery) and a corresponding charger (for Lipo batteries, of course, a Lipo charger).

Gearbox:

• Lancer Tactical Engraved Metal Gearbox Shells
• Steel gears
• delay
• 8mm steel bearings
• 14-tooth steel piston
• Red anodized cylinder for improved surface finish
• Hi torque motor
• QD spring guide with steel base
• Low resistance shielded wiring
• Hi speed metal trigger
• Electronic "Fast trigger V3" trigger unit with increased reactivity and higher rate of fire
• 16AWG shielded wiring (rear / Mini Tamiya plug)
• 19k short axis motor

Internal parts:

• 6.03mm precision polished brass barrel
• Full metal hop up unit (V3)
• 50° hop up rubber

External parts:

• Stamped steel body
• Outer steel barrel
• Steel front sight and rear
• Ergonomic steel trigger guard
• Single point steel strap attachment
• Steel cocking lever
• Steel loader stopper
• Steel fire selector
• Mid-cap polymer magazine 200 rounds
• Flash hider with 14mm CCW screw thread (anti-clockwise)"