Hadron Airsoft Designs shows how they installed the Gorilla Airsoft FCU intto a Wolverine Airsoft MTW Inferno 2... "No practice runs here, we install the Gorilla Airsoft FCU for the Wolverine MTW Inferno 2 edition. What you see, is the self learning of the method. The next one we do, will be much quicker. That's how it goes.:)

Had one or two things to learn during this board swap.

Note the direction of the securing pin recesses, and the trigger spring location in the recess.

Check the screw sizes into the horseshoe contact plate. These were a touch slack on this one, and will be replaced. We reached out to Gorilla Airsoft, and they are looking into it.

The module connection cable, is a bit long for the air stock application. This led to some interesting testing of routing. In the end, we fed everything into the grip.

The setup of the unit can be covered in another video. Default settings on the board allow it to function for testing."