Now, pay attention, especially if you already own the ICS G33, or will do some maintenance work as a favour for a friend as Fox Airsoft, after having a brief review of the ICS G33 AEG, now comes out with a video showing how to take down the AEG and show the internals inside... "The ICS G33 has a few unique features that need to be noted when doing a complete breakdown of the body.

1. Remove your mag
2. Punch pin on front hand guard and remove the hand guard
3. Punch the body pin to remove the magwell. (You will your Hop-Up and barrel partially exposed)
4. Remove 3 select phillips screws (shown in video) and make sure to not lose the small nuts on the other side of the gun. (this is important)
   Push the Hop-Up in and rotate it counter 90 degrees counter clockwise to remove it from the housing.

Removing the gearbox and lower receiver

1. Collapse the stock to the side and remove the two small phillips screws on the rear of the gun and remove the stock. This will allow you to lever the gearbox out of the lower receiver.
2. Use a punch to remove the gearbox retaining pin and remove the gearbox from the grip assembly. Be careful to not chop any of the wires or anything like that.
3. Remove the small plastic piece on the side of the gearbox and punch out the gearbox retaining pin.
4. Remove the top rail and the wire at the back of the motor grip.
5. Remove the two screws that hold the motor in place and finally you can remove the motor itself with the wires as well.
6. Once you have done all of this you can easily get inside of the gearbox.
7. With all of these steps you should be able to do a pretty basic teardown of the ICS G33"