Alexander does a quick walkthrough of the Umarex IWI Mini Uzi CO2 Blowback that is available at Airsoft-RUS... "Pneumatic submachine gun IWI Mini Uzi 4.5 mm from Umarex, Germany. The shutter handle moves to open the shutter on the right side of the frame.

The top cover of the shutter is removed in the same way as on a firearm analogue. To do this, press the latch located on the front of the sight, and then remove the cover by pulling it up and back. In this case, you can see the internal structure of the model.

The body is made of high-quality plastic, and the folding stock is made of metal.
Since the model fires steel spherical balls, it has a smooth steel barrel.

Weight - 1240 gr.

The submachine gun is equipped with a silencer simulator made of plastic, as well as instructions in Russian.

With the butt folded, the length of the product is only 355 mm. If you unfold the butt, the dimensions will increase to 594 mm, and with the silencer installed, about 20 cm more will be added. The butt does not have a latch, it is spring-loaded in both positions, so it is well fixed.

In front of the weapon there is a small forearm with a corrugated surface to hold it when firing with two hands.

The handle is straight and rather large, but it is very comfortable in the hand.

The model has two switches - manual and automatic. The manual safety is located on the left side, at the top of the handle. When the switch is in the left position, the submachine gun is on the safety lock, in the right position it is ready to fire. The automatic switch is a key on the back of the handle. If you clasp the handle with your hand, then the base of the palm will press the key, and the gun will be removed from the safety lock. If the key is not pressed, then the shot will not work.

The magazine holds 28 steel balls. It is removed by pressing the rectangular button at the bottom of the handle. The balls are loaded in much the same way as in pistol magazines. First, the ammunition rammer is moved down and fixed, and then the balls are loaded into a special magazine hole. To install the spray can, with the magazine removed, disconnect the right pad on the handle. Then in the middle of the handle a compartment for the cylinder will become available. Below is a clamping screw for spinning the can.

The submachine gun is equipped with a diopter sight. The reversible rear sight has two positions with different hole diameters for accurate and quick shooting. The model shoots self-cocking, single shots."