Eagle6Airsoft show you how to install the Ternisoft MK Zero MOSFET on the Tokyo Marui SCAR-H New Generation AEG... "This is a trigger mosfet unit from Ternisoft in Italy.  It replaces the mechanical trigger unit and gives you faster trigger response.  We recommend you use our workshop services to have this unit professionally installed.  Available in front and rear wired options.

• MK-ZERO Manual
• Rear Wired
• 2 Years Factory Warranty
• Electronic Fuse
• Electronic Trigger
• Battery settings (LiPo, LiFe)
• Cycle Detection
• Gear Detection
• Configurable Precocking
• Burst Mode
• Ramping Mode (when burst activated)
• Advanced Active Motor Break
• Full Cycle Mode
• ROF Control And Stabilization
• Battery Settings up to 14.8 LiPo
• Low Battery Detection
• Configuration By Trigger
• Active Motor Break
• Factory Settings Reset
• Every single unit Factory tested!
• NO POLARITY PROTECTION
• Installation by reputable tech recommended
• Damage to wires, switches or board by incorrect installation not covered by warranty"